Nitrogen Gas Filter

GTS Filters designs and manufactures a wide range of compressed gas filters like Nitrogen, Oxygen, Natural Gas, SF6, Carbon-di-Oxide, Bio-Gas, and others. Our designs are tailormade to customers' specifications. Compressed gases are expensive and find uses in many process applications. The compressed gas filters are for the removal of dirt, dust, rust, condensation, moisture content, and oil impurities. We design a compressed gas filter with various parameters of compressed air like flow rate, line size, operating pressure, Operating Temperature, and Filtration Rating. We offer compressed gas filters with Aluminium, CS, and SS housings, depending on compatibility and pressure rating. Compressed gas filter elements made of various filter media like paper, synthetic, polyester, pp, coalescing, borosilicate glass fiber, activated carbon, HDPE, non-woven, stainless steel wire mesh, sintered bronze, sintered wire mesh, and sintered ss. We also offer a scrubber system for moisture separation from the compressed gas.
Compressed gas filters are classified under the below categories.
    MS – Moisture Separator For the removal of 99% of bulk oil/water removal from the compressed air.
    SB – Pre-Filtration Sintered bronze filter elements for removal of pipe scales, bulk liquid, solid p[articles, and dust down 5 microns. These filter elements are available in 5, 10, 25, and above microns.
    PF – High-Efficiency Fine Filter For the removal of particles down to 1 micron including coalesced liquid water and oil, dust, providing a maximum remaining oil aerosol content of 0.5 mg/m³ at 21 °C.
    UF – High-Efficiency Oil Removal Filtration For the removal of particles down to 0.01 micron including oil aerosols, and dust, providing a maximum remaining oil aerosol content of 0.01 mg/m³ (0.01 ppm) at 21 °C efficiency – 99.99% (install in series with filter type PF). [Borosilicate glass microfibers – filter media that actively repel oil to reduce pressure drop and running cost to an absolute minimum.]
    AC – Activated Carbon Filtration For the removal of vapor and hydrocarbon odors giving a maximum remaining oil content of  <0.003 mg/m³ (<0.003 ppm) (excluding methane) at 21 °C (install in series with filter type PF + UF).